Ten Aces Medical Adhesive Spray

Product Description

At last, a replacement aerosol spray medical adhesive for breast forms to replace Hollister 7730 Adhesive for those of you who prefer an aerosol spray glue. This new product is very similar in application and sticking ability of our past aerosol glue. However, this new product comes in 2 sizes: 50ml and 100ml. The 50ml size is TSA approved for travel.

Good quality breastforms have a strong polyurethane outer coating that allows for attachment to the body with approved medical adhesives like Ten Aces Medical Adhesive Spray. If using adhesive then Ten Aces spray adhesive is the safest aerosol adhesive product on the market today both for you and your forms. NEVER use two different types of adhesive at the same time otherwise you run the risk of a chemical reaction/interaction that may be detrimental to your breast form or your skin. This Hollister 7730 Adhesive replacement is the one recommended for use with Aphrodite Breast Forms.

PREPARATION:

To maximize the adhesion always wash the area of skin in question first and we strongly recommend the skin area is clean-shaven. After washing you should then rub alcohol or witch hazel over the clean area to remove any soap residue. Soap tends to remain on the skin when washing and will act as a barrier between the skin and adhesive, thus leading to an unsuccessful attachment.

ATTACHMENT: 

Firstly, put on a bra that gives the form a nice secure fit. Next, place the forms, one at a time, on your chest and trace the outline with an eye pencil onto your skin. Spray a light layer of Ten Aces Medical spray adhesive onto the back of the breastform and allow it to set for 3 -5 minutes (some people prefer leaving a gap at the bottom end of the form which will allow the silicone breast to move more easily with the body). Place the form in the pre-marked area and rotate the form lightly so that the adhesive transfers to the skin. Remove, spray the form again and leave to rest whilst you do the same with the other form/side of chest. Once the adhesive on the back of the re-sprayed forms has become tacky after a few minutes, place the forms, one at a time firmly onto the previously marked area on the chest that now has a residue of adhesive on it. Then pull up the bra cup to hold the form snuggly against the chest wall. Repeat the process with the second silicone breast form and leave in place supported by the bra for 10-20 minutes. Gently remove the bra and you should be free to move around if you have followed all the steps correctly. Larger forms should always be partially supported with the use of a bra. 

REMOVING THE BREAST FORM: 

In order to detach the breastform- carefully pull the form away from the skin, taking care not to damage the silicone form. After they are removed, breast-forms should have the adhesive residue removed immediately. Use a recommended adhesive remover like the one sold on GlamourBoutique.com from Walker Tape that gently removes tape and Ten Aces medical spray adhesive residues. Use cotton wool to apply the solvent to the adhesive area and then wipe clean. A quick, no fuss method to remove adhesive from forms is to pour some remover onto a large flat dinner plate, place the form adhesive side down, wrap cling-film/plastic-wrap over the form and plate and leave for an hour or two. The adhesive then dissolves. Once adhesive has been removed from the forms, they should be washed in warm soapy water. Regular cleaning, care and maintenance of silicone breast forms will inevitably extend their life.

If it is your first time using breast form adhesive we recommend testing the product on the inside of your wrist first to ensure you do not have an allergic reaction. Please select UPS shipping for this product only.